Introduction to LZ type pneumatic emulsion wet dust collector:

The LZ type pneumatic emulsion wet dust collector is a characteristic product that has been successfully used in steel plant mixing machine dust collectors, hot rolling machine dust collectors, mine sintering, steel plant hot rolling, coal washing, sintering mixing, metallurgical smelting, material drying, various kilns, industrial boilers, etc., and has achieved satisfactory industrial results. This wet dust collector has the characteristics of low investment and low operating costs, with a dust removal efficiency of 90%. The smoke and dust emission concentration at the outlet of the wet dust collector is ≤ 10mg/m3, and the total resistance of the equipment is<1200pa. The equipment has good dehydration performance, simple operation, fewer operating components, easy operation and management, and lifelong technical service.

The LZ type pneumatic emulsion wet dust collector adopts the principle of pneumatic emulsification, combined with traditional techniques such as impact, Venturi, and tube bundle rotary cutting, to achieve a new high in the working efficiency of the wet dust collector.

Principle of LZ type pneumatic emulsion wet dust collector

This wet dust collector is a single cylinder floor standing type. The smoke side enters and exits the structure, and the smoke passes through the double layer atomization device from the smoke inlet pipe to fully combine the liquid and solid to complete dust removal. Then, through the airflow distributor, the liquid and gas are fully stirred, mixed, and divided to complete the dust removal process. Under the action of the fan's gravity, the gas and water pass through the gas water separator to complete three rounds of dust removal. The dust dissolved in water flows back to the circulating water tank through the drainage device. The purified flue gas is discharged through a dehydrator. Dust sinks to the bottom of the pool and is manually or mechanically cleaned.

The LZ type pneumatic emulsion wet dust collector has the following characteristics:

1. This wet dust collector is made of fiberglass or stainless steel materials, and all internal components are made of stainless steel or the entire equipment is made of fiberglass resin, which solves the problem of acid and alkali in flue gas under high temperature, high wear, and high humidity conditions.

2. The wet dust collector adopts a vertical impeller dehydration device with good dehydration performance, which solves the problem of water carrying in the flue gas and makes the fan and flue less susceptible to corrosion.

3. The wet dust collector adopts a single cylindrical structure, which saves space and significantly reduces manufacturing and installation costs compared to other similar products.

4. The main equipment of the wet dust collector uses fewer operating components, reducing operating and maintenance costs.